ADD KEY (Must have two working original keys):
1. Insert the first previously programmed coded keys into
the ignition.
2. Turn the ignition from the 1 (LOCK) position to the 3
(RUN) position. Keep the ignition in the 3 (RUN) position
for at least 3 seconds, but no more than 10 seconds.
3. Turn the ignition to the 1 (LOCK) position and remove
the first coded key from the ignition.
4. Within 10 seconds of turning the ignition to the 1
(LOCK) position, insert the second previously coded
key into the ignition.
5. Turn the ignition from the 1 (LOCK) position to the 3
(RUN) position. Keep the ignition in the 3 (RUN)
position for at least 3 seconds, but no more than 10 ì
seconds.
6. Turn the ignition to the 1 (LOCK) position and remove
the second coded key from the ignition.
7. Within 20 seconds of turning the ignition to the 1
(LOCK) position and removing the previously
programmed coded key, insert the new un-programmed
key (new key/valet key) into the ignition.
8. Turn the ignition from the 1 (LOCK) position to the 3
(RUN) position. Keep the ignition in the 3 (RUN)
position for at least 6 seconds.
9. Remove the newly programmed coded key from the
ignition.

If the key has been successfully programmed, it will
start the vehicleÆs engine and will operate the remote
entry system (if the new key is an Integrated Keyhead
Transmitter). The theft indicator light will illuminate
for 3 seconds and then go out to indicate successful
programming.

If the key was not successfully programmed, it will
not start your vehicleÆs engine and/or will not operate
the remote entry features. The theft indicator light
may flash on and off. Wait 20 seconds and you may
repeat Steps 1 through 8. If the failure repeats, bring
your vehicle to your authorized dealer to have the
new key(s) programmed.

To program additional new un-programmed key(s),
wait 20 seconds and then repeat this procedure from
Step 1.